Robots aren’t just used in science-fiction films. Robots are used across a variety of industries, such as healthcare and manufacturing. There is an International Robot Exhibition is held in Tokyo every two times in the year. Today, robots can perform everything from putting bolts in the vehicle to filling up the bottle of pills. They also have the capability of flipping pancakes. It’s not easy to build an intricate robot, however it takes only a couple of minutes to build one that can move around.

1. In order to ensure that the chassis is functioning, try testing the chassis using your remote. Screwdriver: Dismantle screws that hold the truck’s body on the chassis. After that, pull gently the antenna into the hole. Attach the bumper. Put aside any spare screws and other parts.
   The block of wood should be inserted in the opening of the tub. Then sand it to ensure it snugly fit into the tub’s mouth, if it’s too large. The chassis must be put over the top of the opening with the wheels pointing upwards, with the front of the car should be touching the wood block. The flat area of the chassis that is just above the compartment for batteries should be secured onto the blocks. Be careful not to glue any other thing. The body of the robot.
   
   When the glue has dried Once the glue is dry, flip the robot to ensure that the side with an open top is facing downwards. Its lid must be aligned with the lower part. It’s important to ensure to make sure that the lid is facing upwards, to allow you to secure it later. Make a hole in the lid and body of the robot with a drill. Through the hole, you can insert the bolt. After tightening the bolt, place two washers on the bolt. The lid needs to be connected to the body of the robot. Attach the lid to the container in a way that it’s upside down.
   For attaching the front bumper onto the chassis of the truck, make a hole in the body of the robot. Attach the body of the robot to the truck’s chassis with bolts and nuts. Make use of two flat washers. The body’s two sides must be secured to the chassis. Make sure that the wheels can move freely. Attach the antenna to the robot.
   Two holes should be drilled next to one another in the body of the robot, until there are eight holes spread equally across its length. The wire ties should be wrapped over the foam noodles, then put them in the holes. The robot can be controlled remotely.
   Things You’ll Be Needing
   • The body of a remote-control truck
   • This same truck is operated via remote control
   • 1.5 bag of laundry basket
   • Container with lid to hold storage in plastic
   • Noodles made from plastic foam
   • A 1-by-2-sized piece of wood
   • Screws
   • Magnets Tiny Neodymium Magnets
   • Epoxy adhesive
   • Tape
   • Long nylon wire ties
   • Sandpaper
   • Nuts
   • Bolts
   • Flat washers
   • Screwdriver
   • Drill
   • Magnets 2 1/2×1/2″ ceramic
   • Safety glasses
2. Also, check out our tips
   • Spray the robot with paint or even add glitter.
3. Warns

If you are handling drills, be sure to wear safety glasses. Make sure you have an adult with you.